'59 Plymouth Forum

Thanks Matthew Removed them today I note there's not much room to feed the cables thru Not sure if it's because I have the 2 door hard top motors but it looks like the wire will get pinched when the windows go up and down? Managed to install the other rear window and it's working All hydraulics are ...

Cheers Matthew

Given your statement am i to feed the wire from behind and feed it thru the hole? Therefore needing to remove the plate so that the switch fits in it!

Amazing what sleeping does to the brain Woke up in the middle of the night and realized I'd put both extended hoses on the same side Given the restriction of the joiner I assumed this may have been the cause Went out into the garage swapped them around and walla problem solvered Then went back to be...

Managed to get one of my rear power windows working today Came out really great - just need to lower the stop so the top of the window will line up with the weather trim You may or may not recall the cvt had manual windows I kept the power option out of my HT and had them modified to fit the conv I ...

Pic of plastic cover over power seat

Don't think the seat is all the way
I'll see if I can hook up power and put it in its lowest position

Thanks guys

the only issue is i have a 6 way power seat so its sits pretty high

the manual cover wont cover the whole assembly and it looks a bit strange

i will post a pic tonight

Hi Dan Detail attached - they come from France Don't threat about the covers, they can be attached at any time However , by any chance does anyone have a pic of the plastic covers for the power seat assembly? I've seen 1958 ones on the KPUSA website- wondering if these can be modified for the swivel...

IMG_5939.JPG IMG_5939.JPG Hope all are well Some more updates Trans lines in, shockers in ( managed to get some Kyb style ones) reworked radiator in (the bottom outlet clashed with the oil filter, must have been a radiator from a 318) Exhaust are currently being made Started on the power window swi...

Bit more of an update Finished most of the wring install Got the car on the hoist and started on the transmission mount The 61 727 trans mount fell short by about 140mm from the trans cross member I made up a plate so that I could still use the original style trans mount Apart from this the hand bra...

Thanks Ron

The link was of great use - i thought that thats where it goes

Cheers

Vic

Howdy

Pics of the light attached

Howdy

Believe it or not i got one out of an Australian assembled RHD 59 plymouth

it has a bracket on it that looks like it connects to the trunk tension rods

Its a switch type - im thinking of taking the feed off of the interior lights

will keep you posted and take some pics

Hi all

Just wondering if anyone has a trunk light they might be able to take pictures of

Looking to install one in my car

Cheers

Vic

Howdy By any chance would anyone have the rear interior light socket for the cvt rear arm rests Turns out I have the lenses but not the light socket Given the forked prongs on the rear of the housing I assume it's a special fitting? Any pics would be great so I can start tracking down what I need on...

Thanks for the offer

I will see what i can do at this end first.

And oh the memories of scrapping off old that tar

I ended up doing twice as i did it on my hard top floor initially and then once i bought the CVT, had to do it all over again!!