'59 Plymouth Forum

I changed out my Plymouth spindles for 1977 dodge Aspen spindles. The bolted on fin but my passenger side wheel sits cambered. I know others have done this same swap. How could I fix this.

Anyone have the part number for tie rod ends. And is there any tie rod ends cheaper than 100 dollers each. That's all the can find at the parts stores where I live.

Is this my heater box just wondering since it has 2 mini radiators. But anyway could I bondo this or fiberglass it. I'm looking to eventually use the heater in my car and wondering what would be the best way to repair it.

I dropped a 318 with a 904 I got ahold of and I can't get the wiring to the ignition right. When I turn it over the starter stays spinning. Another thing is how do I wire the alternator should I wire it to a voltage am gauge. This some hard stuff hopefully someone can help.

Really weird question but has anyone ever put a air conditioning unit in there Plymouth. I have a parts car I bought and was sitting here thinking about it useing a 77 Aspen air conditioning / heater core with plumbing to the 318 out of the Aspen. My Plymouth had a engine but the block was cracked s...

I was messing with my brakes I took one side down to just the spindles and it feels like it wiggles up and down could this be the ball joint how do I replace them and are they pressed or screwd in.

Has anyone ever done a frame swap on a 59 Plymouth belvedere. I was just thinking I saw a post about it and someone used a Dakota frame. My 59 does not have the original engine and trans so I have no ebrake on top of that my the passenger side leaf spring is busted and was thinking aaj brake convers...

OK guys thanks for the help its been a while since I've gotten on here but I pulled the old master cylinder and replaced it with the 78 duel master and bolted up fine now for the plumbing. Could I use what I have or will I need to add a different proportional cable to split the front and rear. I was...

Thanks for the info your Plymouth looks sweet

What would I have to do to use the master cylinder for drum brakes. I eventually want disc. My master cylinder is shot and figured instead of buying on if I could make the dual cylinder work. Thanks for the reply.

Can I use a dual master cylinder I have one from a 78 dodge and looks like it will bolt right on what would I need to do to make this work

Thanks 900 bucks if alot I was trying to do a really low budget disc break build is there anyone that has done this.

Would disc brakes from a 1982 new yorker fit my 59 belvedere. Looks pretty close anyone on here every attempt this.

Not losing fluid its a brand new master cylinder

my brakes work fine but if I let my car sit for a few days the petal goes to the floor then I pump it and its fine again. I have no booster so what else could it be did the brake petal have a spring down there to hold it from slowly settling to the floor.